Home→Forums→MonoBrick Communication Library→Setting up→Reply To: Setting up
April 14, 2014 at 07:18
#4154

Anders Søborg
Keymaster
Hi Antonio
As you suggested me, I am trying to use standard firmware, with the monobrick communication library to be able to control de ev3 brick from my mac computer.
If this is the case then you don’t need to
*install monobrick in a sd and make it run in the EV3
* connect the EV3 to wifi
* upload a program through terminal (Mac OS), like here:
Instead you need to take out the SD card so the EV3 boots the standard firmware and not the MonoBrick Firmware. Then have a look at the programming guide for the MonoBrick communication library which can be found here…
Anders
Follow