Home→Forums→MonoBrick EV3 Firmware→Gyro stops updating
This topic contains 1 reply, has 1 voice, and was last updated by 544449 2 years, 7 months ago.
I have encountered a problem with gyro. After few seconds of repetitive reading, gyro value stops updating.
I tried same test on ev3dev image and there was no problems.
Monobrick image was downloaded from the site and dll build from git sources.
Attached is the plot of (not smooth) rotation around its axis. You can see flat line at the end.
Nevermind… it was cable problem…
You must be logged in to reply to this topic.